Ademix Acrylic 600
Ademix Liquid Membrane
It is an elastomeric resin-based, silicone aterproofing coating.
Provides excellent moisture and water insulation..
Enables easy waterproofing on cracks.
Thanks to the reinforced resin and silicone, shows more effective resistance against mechanical impacts.
Thanks to the biocide in its structure, no bacteria formation occurs on the material.
It is not affected by temperature change. (-30 ° C ± 70 ° C)
Used in Terrace roofs, Foundations, Foundation piles, Reinforced concrete terrace roofs, Water tanks, Positive insulation of basement concrete curtain walls, On plaster and screed, Swimming pools, Protection of concrete and iron reinforcement against corrosion, Positive insulation of Balconies and tunnels.
The surface should be strong, dry, clean and self-supporting. The surfaces to be painted, all kinds of dirt, dust, loose layers should be cleaned and the necessary surface repair and restore operations should be done. All kinds of oil, grease, rust residues that will weaken adherence should be removed from the surface before application.
If it will be applied for the first time, it is thinned with 30% water according to the desired consistency and applied as a single layer as a primer, the second layer is applied without thinning. The second layer is applied without thinning (+) horizontally and vertically in two layers
Thinning rate: 20% first coat primer application with water
Application temperature (°C): 5 – 35
Covering area (m² / kg): 1-1,5 (in one layer) There may be changes in consumption according to the type, absorbency and structure of the application surface.
Resin: Elastomeric resin
Gloss : Flat
Solid content (by weight)% : 61-63
Viscosity (25°C-KU) : 130-140
Density (20°C-gr/cm³) :1,35-1,40
Ph (25°C) : 8-9
Drying time (at 20°C, 65% HR)
First drying (hours): 12
2. Floor duration (hours): 24
Final drying (hours): 24-48 hours (Depending on the ambient temperature and relative humidity, the drying time may vary.)
Tensile strength : 45 kgf/cm2
Elongation at break :%350 -400
It can be stored for 2 years at 5-35°C in its unopened packaging, in a cool and dry place, protected from direct sunlight. Close the packaging cap immediately after use so that it does not contact with air.
20 kg – 10 kg
H317: It causes allergic skin reactions.
If medical advice is required, keep the packaging or label.
P102: Keep out of reach of children.
Read the label before using it.
P261: Avoid breathing dust/fume/gas/mist/vapor/spray.
P280: Wear protective gloves/protective clothing/eye protection/face shield.
P333 + P313: If you show skin irritation or pruritus symptoms : Get medical advice/attention.
P501: Dispose of contents/container in accordance with local/regional/national/international regulations.
*Apply to the nearest health institution for unexpected health problems.