Ademix 215
Ready Thin Plaster
Ademix 215
Ready Thin Plaster
Description:
Cement-Based Polymer and Fiber-Reinforced Ready Thin Plaster
Areas of Use:
It can be used on rough plaster, reinforced concrete, pre fabrics, and gas concrete on indoor and outdoor surfaces.
Advantages:
Easy and fast to apply.
Adapts easily to the applied surface.
Yields good performance with its high adherence.
Provides a smooth surface.
Provides an ideal surface for later processes.
Technical specifications:
Flexural Strength: ≥ 2 N/mm²
Compression Strength: ≥ 10 N/mm²
*The above values were obtained through laboratory tests and are valid for 28 days of the performance.
Performance:
Mortar Type: GP
Dry Bulk Density: 1400 ± 200 kg/m³
Compressive Strength: CSIV
Bond Strength: ≥ 0.3 N/mm²
Capillary Water Absorption: W0
Water Vapor Permeability Coefficient: ≤ 15
Average Heat Conductivity: λ10, dry P = 90% ≤ 0.65
Reaction to Fire: A1
Application Information :
Application Temperature: (+5°C) – (+30°C)
Mixing Ratio: 5 – 6 lt of water / 25 kg of powder
Usable for: 2 hours
Application Thickness: 1-5 mm
Consumption Average: 1.4-1.6 kg/m² (for 1 mm thickness)
*These values are valid for 23°C and 50% relative humidity. Times may vary depending on ambient conditions.
Surface Preparation:
-The application surface should be made clean from dust, dirt, oil, paint residue, and similar foreign matters reducing adherence.
-If there are surface defects, roughness, and eyelet pores, they should be repaired with ADEMIX 215 READY THIN PLASTER 1 day beforehand.
-The floor should be dampened, moistened, and saturated with water.
Mixture Preparation:
25 kg of ADEMIX 215 READY THIN PLASTER is slowly added to 5-6 liters of water. Mixed until a homogeneous mixture is obtained to leave no lumps with a trowel or a low-speed mixer.
The mortar is rested for 5 minutes and is then mixed again and made ready for use.
Application:
The prepared mixture is applied on the surface with equal thickness with a steel trowel. Gauged with an aluminum gauge. When the surface starts to harden (in about 4 hours), it should be feathered with circular movements and without pressure with a trowel. For smooth surfaces, wipe with a damp sponge. Wiping should be done immediately after feathering, and the sponge should be cleaned frequently.
Surfaces, where ADEMIX 215 READY THIN PLASTER is applied, must be moistened within 12-24 hours. The second humidification should be done 24 hours after the first humidification. The surface should be moistened for 2-3 days. Further irrigation increases material performance.
– ADEMIX 215 READY THIN PLASTER should be applied layer by layer in places requiring application thicker than 3 mm.
To apply coating, paint, etc. on surfaces where the plaster has been applied, at least seven days should pass after the application of plaster.
Should not be applied in temperatures below -5°C.
-It should not be applied on surfaces that are exposed to direct sunlight and wind without taking protective measures.
-Foreign materials should never be mixed into the mortar.
-After application, all used tools should be washed with plenty of water before drying.
Warnings:
Do not breathe the product directly, as it is cement-based. Avoid contact with skin and eyes.
Reference Standard:
-TS EN 998–1
Color:
White-Grey
Package:
25 kg. kraft bag
Shelf life: 12 months in dry environment and in original packaging