Sorularınız mı var?
(+90) 486 534 20 73
Sorularınız mı var?
(+90) 486 534 20 73
Ademix

Ademix Brüt Beton

Construction Chemicals​

Primers

Ademix Exposed Concrete Primer

Exposed Concrete Primer

Ademix Exposed Concrete Primer 

Product Description:

Styrene acrylic-based, interior and exterior primer developed to increase the surface adherence of exposed concrete surfaces, walls and cement-based plasters.

Properties:

Increases the adhesion of cement-based plaster mortars to exposed concrete surfaces. 

Prevents rapid water loss of cement and especially gypsum-based plasters

Creates a solid, reduced absorbency and increased adhesion for the top coat.

Increases the working time and workability of the surface.

Prevents salt formation on the surface. Prevents the absorption of the top coat on the surface and allows moisture to escape with its breathability. 

Prevents premature drying and reduces paint consumption.

Decreases the moisture absorption of the surface and increases the vapor permeability.

Areas Of Use:

Applied before applying gypsum and cement-based mortar on exposed concrete surfaces. Used as an adherence enhancer on surfaces such as exposed concrete walls, columns, ceilings. 

Surface Preparation:

The surface should be strong, dry, clean and self-supporting. The surfaces to be painted, all kinds of dirt, dust, loose layers should be cleaned and the necessary surface repair and restore operations should be done. All kinds of oil, grease, rust residues that will weaken adherence should be removed from the surface before application.

Application:

 If it will be applied for the first time, it is diluted with 30% water according to the desired consistency and mixed for 3-5 minutes and a homogeneous and lump-free mixture is obtained, then a single layer is applied to the previously prepared surface with a lambskin roller. During the application, the product should be mixed at regular intervals.

  

Thinning And Application Properties : 

Thinning rate                  : 30 % with Water

Application temperature (°C): 5 – 35

Covering area (m²/lt): 8-11 (Single layer) Depending on the type, absorbency and structure of the application surface, there may be changes in consumption. 

Technical Specifications: 

Resin :  Styrene acrylic copolymer

Gloss :  Flat

Solid content (by weight)% :  68-70

Viscosity (25°C-KU) :  105-110

Density (20°C-gr/cm³)                          : 1.50-1.60

Ph  (25°C)                                                 : 8-9

Drying time (at 20°C, 65% HR)                         

Touch dry (minutes)       : 30 – 60 

Waiting time between layers (hours)     : 4-6  

Final drying (hours): 12-20 hours (Depending on the ambient temperature and relative humidity, the drying time may vary.)

Storage: 

It can be stored for 2 years at 5-35°C in its unopened packaging, in a cool and dry place, protected from direct sunlight. Close the packaging cap immediately after use so that it does not contact with air.

POS NO :10.300.1153 

Packaging Information: 

12 kg

Health And Safety Information: 

Hazard Statement 

 H317: It causes allergic skin reactions.  

Precautionary Statement:

 If medical advice is required, keep the packaging or label.

 P102: Keep out of reach of children.

 Read the label before using it.

 P261: Avoid breathing dust/fume/gas/mist/vapor/spray.

 P280: Wear protective gloves/protective clothing/eye protection/face shield.

 P333 + P313: If you show skin irritation or pruritus symptoms : Get medical advice/attention.

 P501:  Dispose of contents/container in accordance with local/regional/national/international regulations.

*Apply to the nearest health institution for unexpected health problems.