ADEMIX 7503 POL WATERPROOF UV
Polyurethane Based UV Resistant Topcoat Coating Material
It Is An Aliphatic Polyurethane Based, Double Component, UV Resistant, Topcoat Coating Material.
Areas of Use:
It is applied as a final coating in the protection of polyurethane waterproofing materials in roofs, terraces, verandas and balconies, stadiums and outdoor car parks, industrial floors, light roofs made of metal and fibrous materials, bridge platforms.
It is easy to apply.
It is resistant to UV rays.
It has high abrasion and chemical resistance.
Due to its aliphatic structure, it protects the color, does not discolor and turn yellow when exposed to sun rays.
It maintains its mechanical properties at temperatures between -40 ˚C and +90 ˚C.
It provides effective resistance against chemicals.
It has high adherence to the applied surface.
Density: 1,15 ± 0,10 gr/ml
Shore A Hardness: 60
Elongation at Break: ≥ 100%
Adhesion to Concrete Strength: ≥ 2 N/mm²
Application Temperature: (+5°C) – (+30°C)
Mixing Ratio: 18 kg Component A / 6 kg Component B
Mixture Pot Life: 45 minutes
Ultimate Curing Time: 7 Days
Average Consumption: 0,150-0,300 kg/m²
*These values are valid for 23°C and 50% relative humidity. Times may vary depending on ambient conditions.
-The surface must be clean and dry, and free from oil, dirt, grease, coatings and other dirt that will prevent adhesion.
-Large fractures and faults must be repaired beforehand.
-The cement crust and glossy screed sanding on the concrete surface should be cleaned with tools such as a notching machine, diamond drum wiping machine, driven grinding, and the surface should be roughened and wiped.
-The entire surface of the industrial vacuum cleaner should be cleaned from dust.
-The surface should be prepared by priming with ADEMIX 7501 POL PRIMER.
By adding component B on component A, ADEMIX 7503 POL WATERPROOF UV should be stirred with a 300 – 400 rev/min mixing bit drill for 2 -3 minutes until a homogeneous consistency is obtained.
The components are packed in the correct mixing ratios. If some of the product will be used, this ratio should be considered. Attention should be paid to the consumption of the prepared mixture within the pot life.